ScaleBlaster SB-MAX Guía de instalación descargar pdf (Pagina 4)

LOCATION OF THE SB-MAX UNIT

1.) The most desirable place to install the unit is on the main water line that enters the house.

2.) The power unit should be mounted on a wall or other solid surface within five feet from an electrical

outlet and within ten feet from where the pipe will be wrapped.

3.) Once the main water inlet pipe to the house is located, identify a section of pipe that is at least 12

inches straight and at least two feet away from any major electrical interference, example - an

electric motor.

Installs on the incoming water supply line

main water

shutoff valve

water going to house

Important! For best results, wrap signal cable on a

straight section of pipe of 12” or more. Keep the

signal cable as far away as possible from tees,

elbows, couplings, valves and any curved pipe.

Keep signal cable at

least away

from any major

electrical interference.

No more than

of wire is allowed

between the power box

terminals and the

signal cable location

wrapped on the pipe.

Keep wires from

touching each other -

going from the

terminals to the signal

cable location on the

pipe.

Install the signal cable

on the incoming cold

water supply line

entering the home as

close to where it comes

into the house as

possible.

two feet

ten feet

At least 12 inches of straight pipe

SB-MAX comes with a

5 foot power cord.

1 2 3 4 5 6 7 8

Sin comentarios

ScaleBlaster SB-MAX Guía de instalación Pagina 4